One in four car crashes actually occur from the side, so when it comes to car seats side impact protection so important. Installing a car seat properly is important as well. Be aware that the installation process can be tricky plus that it is time consuming.
Britax Boulevard is well known for its safety. Also, the installation process is not as difficult as one might expect.
Convertible Stroller
First of all, you need to lift the cover from the front of the car seat. Next, you have to open both of the lock-offs. This seat enables you to use both lock-offs, however prefers the use of a lock-off on the side opposite of he buckle. Once you are all done with this you should run the seat belt under the comfort foam and than just buckle.
In case the car seat accidentally locks in the retractor, just leave it unlocked. Just check whether the seat is twisted.
Next, grasp the shoulder portion of the seat-belt closest to the LATCH plate and pull tight. Many people believe that this is the most important part of the process. And they are right. This process needs to be undertaken thoroughly. Press down on the side of the car seat closest to the buckle. It is very important to make sure the seat is very tight. Right after you are done smooth the shoulder belt through the belt path and make sure you close the second lock-off. There should be not more than 1 inch (which is equivalent to roughly 2.5 cm) side-to-side and front-to-back at the belt path; that is how tight it should be.
Right after installing car seat it is strongly advisable that you use the top tether when rear facing. It enhances safety when you install a Britax Boulevard with a seatbelt.